Well, decision made. Liner is out on starboard side. Any suggestions on type of glass and
And how many layers would be appreciated. Pictures are on the gallery. I can’t figure how to move
Them here. Ok with boats, not to much with technology. LOL
Posting pics in topic - You have the pics in your gallery, that was the hard part. Now follow from step 8 in this thread to copy the IMG code from the gallery and post into your topic. It is best to open two tabs in your browser, one to your topic and one to your gallery in the photo gallery.
https://classicaquasport.com/smf/index.php?topic=12725.0You asked about glass: What is your rebuild plan as far as resin? Are you planning you laminate a layer onto the hull sides and down to the first stringer?
Did you save what you cut out of the liner so you can glass it back in?
What is your plan for finishing the inside of the boat - gelcoat or paint?
If you are planning to use epoxy to laminate the hull but had planned to use poly resin so you can gelcoat, you can do this if you saved the liner. You use epoxy for the strength and then cover it visually with the liner, which usually does not attach to the hull. It even allows you to install the new floor all the way out to the hull sides, connect to the hullside with epoxy and then hide that connection with the liner. I used epoxy below the floor and poly above.
