1
Generic Aquasport Rebuilding Topics / Re: 1973 196 rebuild question
« Last post by Duffy1470 on Today at 07:42:22 AM »Thank you Ulysses. I plan to do the following to the stringers:
1. Obviously grind, seriously though, rebuild them to transom
2. Laminate Coosa to the outside of the stringers
A. From the back of the gas tank locker to transom
B. From as far forward as my wallet can stand on outboard side to transom
I am going to raise deck 2ish inches with the plastic fence posts. Why does everyone glass on inside of stringers. Seems like a huge unnecessary pain in rear? Also, there is a thru hull transducer hole almost perfectly placed right in front of where forward most part of a splash well would be. Does anyone think it feasible to put a livewell there that drains into the splash well. A livewell that goes all the way to the hull bottom like a gold line. Creates lot s of "where does my bilge pump go?" Issues, but seems like a really cool idea. Thoughts?
1. Obviously grind, seriously though, rebuild them to transom
2. Laminate Coosa to the outside of the stringers
A. From the back of the gas tank locker to transom
B. From as far forward as my wallet can stand on outboard side to transom
I am going to raise deck 2ish inches with the plastic fence posts. Why does everyone glass on inside of stringers. Seems like a huge unnecessary pain in rear? Also, there is a thru hull transducer hole almost perfectly placed right in front of where forward most part of a splash well would be. Does anyone think it feasible to put a livewell there that drains into the splash well. A livewell that goes all the way to the hull bottom like a gold line. Creates lot s of "where does my bilge pump go?" Issues, but seems like a really cool idea. Thoughts?