Menu

Attention: Have 2 pages to see today
« previous next »
Pages: 1 2   Go Down

Author Topic: Replacing fenders  (Read 1675 times)

June 22, 2012, 11:33:48 AM
Reply #15

daniel123

  • Information Offline
  • Posts: 381
Re: Replacing fenders
« Reply #15 on: June 22, 2012, 11:33:48 AM »
When I explained the situation and that there are no dealers anywhere near me, Continental offered to send me the fender I need! Nice folks...

Dan
Logged
June 22, 2012, 08:33:05 PM
Reply #16

RickK

  • *****
  • Information Offline
  • Administrator
  • Posts: 11278
Re: Replacing fenders
« Reply #16 on: June 22, 2012, 08:33:05 PM »
Good customer service  :salut:
Logged
Rick
1971 "170" with 115 Johnson (It's usable but not 100% finished)

1992 230 Explorer with 250 Yamaha
June 25, 2012, 12:05:12 AM
Reply #17

floridamisser52

  • Information Offline
  • Posts: 72
Re: Replacing fenders
« Reply #17 on: June 25, 2012, 12:05:12 AM »
Quote from: "daniel123"
My 200 Osprey came on a nice Continental aluminum trailer, nice but for one fender, which took a hit hard enough to split it. The former owner said it might have been caused by a (darn violent) blow-out. Anyway, I need to fix or replace it. Any ideas or advice welcome; photo below.
I almost had a violent blow out on my 98 175 with a continental trailer. The galvanized arxle rotted from gtthe inside out and the axle broke at the wheel. Was going slow so I faired ok. However at highway speed would have been an issue. It looked great on the outside. Beware salt water boaters!
Logged
Pages: 1 2   Go Up
« previous next »
 

SimplePortal 2.3.5 © 2008-2012, SimplePortal