Marc, thank you again for all of your help, VERY MUCH appreciated my friend 
I went ahead and paid them, but am holding off on the shipping. They have some nice pop-up bow lights, cleats etc. that I may throw in the box, and also want to again measure the console and figure out where the switch panel needs to go. May grab one of those as well.
Bob, that is a helluva good idea, the cardboard template in order to properly assemble the wiring harness. Certainly will take you up on that, and thank you sir!
The way this rebuild is going...let's pencil in the second week of September...
Thanks guys!!
...of which year?
Marc, if I can be of service, give me a call. Scott, if you remember the Talon I rewired, here's how I did the template...
Allowed me to "pre-wire" the gauges...
...creating a harness. It would have been a b!tch simply installing the gauges in the helm and then try to wire them. As it were, it still took me a couple hours to get the harness wired up due to the confines of the dinky little console. As you can see, it was pretty small...
