Attention: Have 2 pages to see today

Author Topic: tower install info on a 22 flatback  (Read 970 times)

October 18, 2010, 09:22:30 PM
Read 970 times

Capt Matt

  • Information Offline
  • Master Rebuilder
  • Posts: 791
    • http://www.captmattmitchell.com
tower install info on a 22 flatback
« on: October 18, 2010, 09:22:30 PM »
I have a 69 22 flatback that I'm doing a total rebuild on.
I purchased a 1/2 tower for her and am trying to work out how far back to mount it.
When I drew out the layout for the boat I came up with a center point to use as a reference. I'm mounting the fuel tank (50 gal) forward and rigging her with a 21 inch set back porta bracket.She will also have a 40 gal livewell/ leaning post. I planned on mounting the tower back 11/2 feet back from the center of the boat but am concerned that the  boat will drain water back and handle well. I raised the floor 4 inches.
Is there a way to come up with the center of gravity and how far back I should mount the tower without putting her in the water.
Any info from anyone that has installed a tower on one of these boats would be much appreciated.
Thanks
Capt Matt
www.captmattmitchell.com
Light tackle sportfishing

October 18, 2010, 10:30:26 PM
Reply #1

seabob4

  • Information Offline
  • Rigging Master
  • Posts: 9087
Re: tower install info on a 22 flatback
« Reply #1 on: October 18, 2010, 10:30:26 PM »
Some measurements from the Doc's 22-2 may help...


I'll be down at his place next week, if you want me to get some for and aft, side to side dim.'s...


Corner of 520 and A1A...

October 19, 2010, 02:43:29 PM
Reply #2

Capt Matt

  • Information Offline
  • Master Rebuilder
  • Posts: 791
    • http://www.captmattmitchell.com
Re: tower install info on a 22 flatback
« Reply #2 on: October 19, 2010, 02:43:29 PM »
Thanks Seabob that would help alot. Is that the boat that was done on boatbuilder.com?
Matt
www.captmattmitchell.com
Light tackle sportfishing

October 19, 2010, 09:45:02 PM
Reply #3

seabob4

  • Information Offline
  • Rigging Master
  • Posts: 9087
Re: tower install info on a 22 flatback
« Reply #3 on: October 19, 2010, 09:45:02 PM »
Quote from: "Capt Matt"
Thanks Seabob that would help alot. Is that the boat that was done on boatbuilder.com?
Matt

Yep...


Corner of 520 and A1A...

 


SimplePortal 2.3.5 © 2008-2012, SimplePortal