Attention: Have 2 pages to see today

Author Topic: 1971 19-1 Osprey Rebuild (any help is appreciated)  (Read 2974 times)

December 02, 2014, 01:02:41 PM
Reply #30

avidskier

  • Information Offline
  • Posts: 25
Re: 1971 19-1 Osprey Rebuild (any help is appreciated)
« Reply #30 on: December 02, 2014, 01:02:41 PM »
Georgie, thanks a bunch!
I think what I will probably end up doing, for now, is disabling the fuel pump all together.
Since these wires are connected to an alarm at the key switch and I run pre-mixed fuel, in theory, there's no need for the wires to be connected.
Thanks again!

December 02, 2014, 01:13:23 PM
Reply #31

avidskier

  • Information Offline
  • Posts: 25
Re: 1971 19-1 Osprey Rebuild (any help is appreciated)
« Reply #31 on: December 02, 2014, 01:13:23 PM »
Kevin, loved the boatbuildercentral link.
I just couldn't picture in my head how I was going to reglass the outer skin of the transom and the section about using melamine as the backing brought everything back into perspective.
Ryan,
Thanks for the additional footnotes and advice. I agree 100% with everything.
I can't wait to get some additional funds together to start the transom!!!!
I will keep you posted on any progress!
Happy holidays guys

December 27, 2014, 07:47:25 PM
Reply #32

avidskier

  • Information Offline
  • Posts: 25
Re: 1971 19-1 Osprey Rebuild (any help is appreciated)
« Reply #32 on: December 27, 2014, 07:47:25 PM »
Hi folks, hope everyone is having a good holiday.
I ran a across a good motor, at least I think so, and was wondering what your thoughts are.
It's a 1993 Johnson 200 Ocean Runner. Apparently it was just rebuilt, new tilt and trim and 120+/-compression on all cylinders.
I read that this is a gas hog but a great motor and solid dependable motor. They are asking $2,500 but probably wouldn't pay more than $2000 if I was to get it.
Question, Am I crazy to think i can put a 200 HP on my 19-1 Osprey after transom and stringers are rebuilt? If so, should I make the transom beefier due to the heavier motor?
Thanks guys!

December 28, 2014, 12:33:17 AM
Reply #33

Georgie

  • Information Offline
  • Mechanical Master
  • Posts: 481
Re: 1971 19-1 Osprey Rebuild (any help is appreciated)
« Reply #33 on: December 28, 2014, 12:33:17 AM »
Sorry, but a 200 really is a bit too big.  What is the actual weight of the engine?  Aaron (Aswaff) should have some good feedback for you as he had an oversized engine on his 196 before he rebuilt his flatback.
Ryan

1979 246 CCC

1987 Wellcraft 18 Fisherman

December 28, 2014, 08:26:47 AM
Reply #34

gran398

  • Information Offline
  • Purgatory
  • Posts: 7440
    • http://www.ascottrhodes.com
Re: 1971 19-1 Osprey Rebuild (any help is appreciated)
« Reply #34 on: December 28, 2014, 08:26:47 AM »
What is the max HP shown on the plate?

December 28, 2014, 09:49:28 AM
Reply #35

Blue Agave

  • Information Offline
  • Posts: 1495
Re: 1971 19-1 Osprey Rebuild (any help is appreciated)
« Reply #35 on: December 28, 2014, 09:49:28 AM »
Quote from: "avidskier"
Question, Am I crazy to think i can put a 200 HP on my 19-1 Osprey after transom and stringers are rebuilt? If so, should I make the transom beefier due to the heavier motor?
Thanks guys!
Two things to consider;
1) Did you raise the height of the floor?  Your feet will be wet.
2) Do you plan to insure the boat?  If so, getting insurance may be a nightmare.

1975 19-6
3.0 EFI Mercury 150 4S
"Don't count the days make the days count." - Muhammad Ali

December 28, 2014, 10:32:00 AM
Reply #36

Capt. Bob

  • ***
  • Information Offline
  • Global Moderator
  • Posts: 6445
Re: 1971 19-1 Osprey Rebuild (any help is appreciated)
« Reply #36 on: December 28, 2014, 10:32:00 AM »
Quote from: gran398
What is the max HP shown on the plate?

115???.
http://classicaquasport.com/smf/index.php?topic=9274.0

125???
]
Capt. Bob
1991 210 Walkaround
2018 Yamaha 150 4 Stroke
"Reef or Madness IV"

December 29, 2014, 08:05:24 AM
Reply #37

avidskier

  • Information Offline
  • Posts: 25
Re: 1971 19-1 Osprey Rebuild (any help is appreciated)
« Reply #37 on: December 29, 2014, 08:05:24 AM »
Thank You all.
I did not see the "plate" and I'm not even sure where it's located and if it even exists.
I do see the max hp on the spec sheet above is 125 hp so that certainly answers my question.

February 25, 2015, 10:24:13 AM
Reply #38

avidskier

  • Information Offline
  • Posts: 25
Re: 1971 19-1 Osprey Rebuild (any help is appreciated)
« Reply #38 on: February 25, 2015, 10:24:13 AM »
Hi folks, it's been a while since I posted and I wanted to give you an update of where I am today and keep the post going as I think questions will come up as soon as I start my rebuild.
It's sad but true, the boat sits as it did the last time I posted.
I started a side business doing handyman/remodeling work in the hopes of getting enough capital together to start workin on my Osprey. The money part is working well as I am ready to start rebuilding transom but the time part is the problem. I have more work than I know what to do with and I have been working 7 days per week for what seems like an eternity.
Weekends are becoming lighter as I get accustomed to the schedule and type of work so, I hope to start on my transom pretty soon!
Hope you all are well!

February 25, 2015, 06:16:00 PM
Reply #39

RickK

  • *****
  • Information Offline
  • Administrator
  • Posts: 11275
Re: 1971 19-1 Osprey Rebuild (any help is appreciated)
« Reply #39 on: February 25, 2015, 06:16:00 PM »
We're here with any help you need man.  Especially if you need help spending money  :08:

 ;-)
Rick
1971 "170" with 115 Johnson (It's usable but not 100% finished)

1992 230 Explorer with 250 Yamaha

 


SimplePortal 2.3.5 © 2008-2012, SimplePortal