Porta folks are closed to Oct 22, or I would have asked them.
I have a 2-3 old portabracket that is not working at all.
(I assume its the trim switch located on the steering wheel)
Its a pretty typical set up with the hydraulic unit and solenoids inside a closed transom, then the hydraulic lines run out the transom to the actuator.
To test the unit, Can I jump the switch by connecting the blue wire (up) or the green wire (down) to the positive battery post ?
If this doesn't work, then I am thinking its likely corrosion on the solenoids located next to the hydraulic unit.