Attention: Have 2 pages to see today

Author Topic: 22' CCP FLOOR REBUILD: POSSIBLE COST..??  (Read 1115 times)

October 28, 2007, 08:54:42 PM
Read 1115 times

NIGHTIDES

  • Information Offline
  • Posts: 8
22' CCP FLOOR REBUILD: POSSIBLE COST..??
« on: October 28, 2007, 08:54:42 PM »
Just found a 22'CCP w/ a perect hull exterior and the most solid transom I have seen. The one problem area are the soft / spongy areas of almost the whole deck.

What might the $cost$ be for someone to replace and redo the entire deck..?? I wish I could undertake it but cannot at the present time.

Thanks for you comments.

October 29, 2007, 09:04:32 AM
Reply #1

GoneFission

  • Information Offline
  • Mechanical Master
  • Posts: 3479
CCP deck
« Reply #1 on: October 29, 2007, 09:04:32 AM »
Is the whole deck soft, or mainly the center panel over the gas tank?  CCPs had word-core for the center panel, and it often rots, delaminates, and/or gets soft.  Decks are not wood cored and have less problems.

A deck replacement is not a huge job, but the tank tub has to be molded into the decking.  The rest is pretty straightforward.  I would not use wood for redecking, but would opt for one of the composite core materials.  

Hope this helps - good luck!
Cap'n John
1980 22-2 CCP
Mercury 200 Optimax 
ASPA0345M80I
"Gone Fission"
ClassicAquasport Member #209


October 29, 2007, 10:28:26 AM
Reply #2

NIGHTIDES

  • Information Offline
  • Posts: 8
(No subject)
« Reply #2 on: October 29, 2007, 10:28:26 AM »
The whole deck has soft spots throughout. The boat was previously stored w/ the transom higher than the bow and the rain water collected in the cockpit for long time. This is how the softness problem developed I think.

Rest of the hull is mint. Costs..???

 


SimplePortal 2.3.5 © 2008-2012, SimplePortal