Attention: Have only 1 page to see today

Author Topic: Yamaha 250 sho 20in shaft  (Read 350 times)

March 24, 2024, 07:40:25 PM
Read 350 times

eman9502

  • Information Offline
  • Posts: 1
Yamaha 250 sho 20in shaft
« on: March 24, 2024, 07:40:25 PM »
Hello , I’m currently restoring a 1974 222 flat back . I’m getting ready to re power it . Has anyone powered this hull with a Yamaha 250 sho 20in shaft on a porta bracket ? If so how did it perform?

March 25, 2024, 07:19:07 AM
Reply #1

RickK

  • *****
  • Information Offline
  • Administrator
  • Posts: 11275
Re: Yamaha 250 sho 20in shaft
« Reply #1 on: March 25, 2024, 07:19:07 AM »
Welcome aboard eman9502.
The FB model was only produced up through '71. We have seen boats sold in '71 but not registered until '72 but certainly not '74.
We have a member that put a 250 on his flatback and he said that it was too scary to drive anywhere near wide open. The FB was originally designed for a 90 hp and most people are more than happy with a 150hp on it.
Be advised that a FB has a tendency to "bow steer" meaning that if a wave hits at the wrong angle the bow could dig in and all of a sudden you're pointing 90 degrees from where you just were. Pretty dangerous.
If you have a 12 degree hull, which was made in '74, you would be pushing the edge with the 250. most have a 200 or 225. The original specs were for a 140
Rick
1971 "170" with 115 Johnson (It's usable but not 100% finished)

1992 230 Explorer with 250 Yamaha

 


SimplePortal 2.3.5 © 2008-2012, SimplePortal