Rigging Sleeve Hack?

[CTsalt12]

Hi All,

I need to replace my rigging sleeve going from my outboard to where the engine wires and cable meet the hull of my boat.  I need to do this without taking all the wiring/cables out, because that would be a huge PITA.  Meaning, I need a sleeve that I can fit around the cables.

I see I can get a zippered harness here, about 50 bucks shipped.

https://www.overtons.com/modperl/product/details.cgi?pdesc=T-H-Marine-Zippered-Rigging-Sleeve-48&i=316231&utm_medium=cpc&utm_source=googlebase&s_kwcid=googlepla&cvsfa=2587&cvsfe=2&cvsfhu=333136323331&s_kwcid=adwords__&gclid=EAIaIQobChMIx4D645zn2QIVEHZ-Ch0WognLEAQYAyABEgLi7vD_BwE

I'm wondering if anyone knows any nice cheap hacks here.  Was almost thinking a wire loom, but they don't seem to make them above 2.5 inches, which I believe is a bit too narrow.  Any ideas here?

[Capt. Bob]

This is what I used.

[RickK]

Hmmm, did the tool I bought have that hole for a ratchet in it? If it did, I didn't notice and it's genius. (Now I have to go out and check)