Attention: Have 2 pages to see today

Author Topic: Fish tail on motor  (Read 319 times)

December 27, 2014, 05:53:08 PM
Read 319 times

uglystick

  • Information Offline
  • Posts: 27
Fish tail on motor
« on: December 27, 2014, 05:53:08 PM »
Hi all. Hope you had a great Christmas. I just replaced my old Yama 150 on my 87 Osprey 200. Boat is in the carport now being brought up on maintenance. Repaired some broken, rusty, stuff and a dozen other things. Made new rod holders from PVC added a console hatch, etc, etc. My old motor had one of those whale tails on it. I haven't run the newer engine on the water yet but am wondering if anyone runs one stock on a 200? I don't really want to put trim tabs on a 19.5 ft boat. Any advice or thoughts on this subject? I use the boat off the Ms. coast islands and bays &  rivers here. I keep it in a wet slip all spring summer & fall.

December 28, 2014, 10:24:11 AM
Reply #1

Blue Agave

  • Information Offline
  • Posts: 1495
Re: Fish tail on motor
« Reply #1 on: December 28, 2014, 10:24:11 AM »
My advice would be to skip the tail and go with the trim tabs.  Good luck with your decision.

1975 19-6
3.0 EFI Mercury 150 4S
"Don't count the days make the days count." - Muhammad Ali

December 29, 2014, 05:06:49 PM
Reply #2

GoneFission

  • Information Offline
  • Mechanical Master
  • Posts: 3479
Re: Fish tail on motor
« Reply #2 on: December 29, 2014, 05:06:49 PM »
Fins and tails don't work on Aquasports if the engine is set at the correct height.  Do a search and you will find several threads on this.
Cap'n John
1980 22-2 CCP
Mercury 200 Optimax 
ASPA0345M80I
"Gone Fission"
ClassicAquasport Member #209


 


SimplePortal 2.3.5 © 2008-2012, SimplePortal