Welcome, Guest
Login
Register
Search
Home
Forum
Help
Site Rules
Advertise
Login
Register
Menu
Home
Forum
Help
Site Rules
Advertise
Login
Register
Classic AquaSport
/
General Aquasport Forums
/
Aquasport Discussion
/
87 222 Hull Picture, on trailer
Attention: Have 2 pages to see today
« previous
next »
Print
Pages:
1
Go Down
Author
Topic: 87 222 Hull Picture, on trailer (Read 954 times)
April 05, 2006, 10:20:41 AM
Read 954 times
Ben87
Information
Posts:
213
87 222 Hull Picture, on trailer
«
on:
April 05, 2006, 10:20:41 AM »
Here is the portside shot of the girl. Notice the scratches going down the side of the hull just behind the 222 decals and the worn "sp" from the rear logo, I think the rear bumper we had rubbed the big AS decal off and the scratches were from the corner dock braces that were not covered up by a corner bumper so the exposed metal would rip the side when the pilot would make a "crooked landing" on the dock.
How about that bottom paint? Who taped the line for that?, our 6 year old neice? As this was the before shot, I took the time to make it right so now the line is even as it is only cosmetic anyway and I'm not TOO anal about it, but I still made it right. If I remember over the years, the console rail would have a bit of play in it and when running the rough seas it would contact the windshield and crack it, then the crack would run and eventually the plastic/lexan would snap off, there is still enough left and it gives it the "custom-look" that we all so desperately crave, it reminds me of the Hanson Brothers in Slap Shot, they are bashing in the side of their bus with sledgehammers when Paul Newman comes up to them, very nonchalantly and asks, "Hey guys, whatcha' doin'?" and one of the brothers looks up and says, "Were makin' it look mean." That is what it is, it looks "mean." Thankfully one of the guys on here gave me a lead on the windshield place in Fl to possibly get a new one.
One can also see the windshield which is gone in two places for some odd reason.
Logged
April 06, 2006, 07:07:22 PM
Reply #1
OldSchool
Information
Posts:
68
(No subject)
«
Reply #1 on:
April 06, 2006, 07:07:22 PM »
ha that bottom paint line is funny, mabey they were marking it while in the water and it was rough that day...lol
nice boat
Logged
1998 Osprey 175 Evinrude 115
1996 Osprey 200 (sold)
1976 Straight Inboard 22-2 (sold)
April 06, 2006, 08:12:08 PM
Reply #2
JimCt
Information
Posts:
1848
(No subject)
«
Reply #2 on:
April 06, 2006, 08:12:08 PM »
Likely the "artist" was full of beer.
Logged
JimCT
------
\'74 22-2 inboard
HIN:ASPL0953M74J
Chrysler 318
------
\'74 Marshall 22
April 07, 2006, 06:08:14 AM
Reply #3
RickK
Information
Administrator
Posts:
11278
(No subject)
«
Reply #3 on:
April 07, 2006, 06:08:14 AM »
When I had my brakelights/license plate on the top of my guides, the license plate used to carve a nice gouge into the hull down the side whenever I was putting her back on the trailer.
Now I carry a lightbar that I fabricated and has the rear strap built in. It comes off before launch and goes back on after retrieval. No more gouging and no more ground problems.
Logged
Rick
1971 "170" with 115 Johnson (It's usable but not 100% finished)
1992 230 Explorer with 250 Yamaha
April 07, 2006, 02:06:29 PM
Reply #4
Ben87
Information
Posts:
213
(No subject)
«
Reply #4 on:
April 07, 2006, 02:06:29 PM »
I think what was happening over the years is the rearward part of the boat sits against the dock and the water splashes up against the boat leaving a film/slime as the saltwater pond is loaded with marine life so every year we see the staining, whereas the forward part of the boat gets no splashing, hence no slime, therefore, no paint. I evened it out this season though and it looks much better, this is the second season I went with the red, I'll probably go with the blue as I had for all time next season and forevermore.
Logged
Print
Pages:
1
Go Up
« previous
next »
Classic AquaSport
/
General Aquasport Forums
/
Aquasport Discussion
/
87 222 Hull Picture, on trailer
SimplePortal 2.3.5 © 2008-2012, SimplePortal