Attention: Have 2 pages to see today

Author Topic: Seals for Sea Star Hydralic steering  (Read 976 times)

February 21, 2011, 11:54:47 AM
Read 976 times

Far67rar

  • Information Offline
  • Posts: 17
Seals for Sea Star Hydralic steering
« on: February 21, 2011, 11:54:47 AM »
My 17.5 Aquasport has Sea Star Hydralic steering, the seals in the end caps on the ram have started laeking. West Marine want $114.00 for what appears to be the cap and seals. My question is does anyone know where i can buy just the seals

February 21, 2011, 12:10:09 PM
Reply #1

Capt. Bob

  • ***
  • Information Offline
  • Global Moderator
  • Posts: 6446
Re: Seals for Sea Star Hydralic steering
« Reply #1 on: February 21, 2011, 12:10:09 PM »
Quote from: "Far67rar"
My question is does anyone know where i can buy just the seals

Here's a start. Nothing's cheap nowadays.
http://www.surplusunlimited.com/mm5/mer ... ore_Code=1
]
Capt. Bob
1991 210 Walkaround
2018 Yamaha 150 4 Stroke
"Reef or Madness IV"

February 21, 2011, 12:21:38 PM
Reply #2

seabob4

  • Information Offline
  • Rigging Master
  • Posts: 9087
Re: Seals for Sea Star Hydralic steering
« Reply #2 on: February 21, 2011, 12:21:38 PM »
Far67,
The seals are what Teleflex calls "End Glands".  I've replaced quite a few in the last few years, the cheapest I've found has been $94 including the spanner wrench.  And as far as I know, you have to buy the end caps as well as the seals...


Corner of 520 and A1A...

February 21, 2011, 08:20:09 PM
Reply #3

Mark Sr

  • Information Offline
  • Posts: 183
Re: Seals for Sea Star Hydralic steering
« Reply #3 on: February 21, 2011, 08:20:09 PM »
You have to hope you just need the seals on the End Glands.I replaced mine and the steering didn't work right.There's also seals in the hydraulic cylinder itself.They are like check valves.If you go on the Teleflex site and look up the number on your cylinder it will give you an exploded view of the hydraulic pump.I had to buy a new cylinder.
Mark Sr
 
 \'98 Aquasport 245 Tournament Master

February 21, 2011, 09:17:18 PM
Reply #4

seabob4

  • Information Offline
  • Rigging Master
  • Posts: 9087
Re: Seals for Sea Star Hydralic steering
« Reply #4 on: February 21, 2011, 09:17:18 PM »
Quote from: "Mark Sr"
You have to hope you just need the seals on the End Glands.I replaced mine and the steering didn't work right.There's also seals in the hydraulic cylinder itself.They are like check valves.If you go on the Teleflex site and look up the number on your cylinder it will give you an exploded view of the hydraulic pump.I had to buy a new cylinder.

Mark,
If the steering works fine, but you notice some hyd fluid in the splashwell, then all you'll need is the end gland seal kit.  If there are other issues such as jerkiness, dead spots, harder to port than starboard, etc., that bleeding hasn't taken care of, there may indeed be a problem futher into the cylinder...or helm pump, for that matter...


Corner of 520 and A1A...

February 22, 2011, 11:39:15 AM
Reply #5

Far67rar

  • Information Offline
  • Posts: 17
Re: Seals for Sea Star Hydralic steering
« Reply #5 on: February 22, 2011, 11:39:15 AM »
Steering works fine, just leaks alittle out of the end caps. It leaks a very small amount about a table spoon or two a month but I keep the boat in the water and when it rains it gets washed into the bilge where the bilge pump pumps it out into the canal. NOT GOOD!

February 28, 2011, 01:14:52 PM
Reply #6

Far67rar

  • Information Offline
  • Posts: 17
Re: Seals for Sea Star Hydralic steering
« Reply #6 on: February 28, 2011, 01:14:52 PM »
Thank you for the advise, I ended up going to my local hydralic shop they measured the end glands and were able to supply me with all the seals for 27.00

 


SimplePortal 2.3.5 © 2008-2012, SimplePortal