Menu

You reached the limit of pages to see for today
« previous next »
Pages: 1   Go Down

Author Topic: Aquasport construction  (Read 1279 times)

October 10, 2007, 09:20:28 PM
Read 1279 times

GoneFission

  • Information Offline
  • Mechanical Master
  • Posts: 3479
Aquasport construction
« on: October 10, 2007, 09:20:28 PM »
Don't know if y'all saw this in the rebuilds section, but I had to cut a new through-hull for the overboard drain - it's amazing how heavy the fiberglass build on the Aquasport hull is - here is the core from the cut - over 1/2" of solid fiberglass!  No wimpy core or lightweight stuff here!



Back on the water again - see you there!   :lol:
Logged
Cap'n John
1980 22-2 CCP
Mercury 200 Optimax 
ASPA0345M80I
"Gone Fission"
ClassicAquasport Member #209

October 10, 2007, 09:58:10 PM
Reply #1

LilRichard

  • Information Offline
  • Master Rebuilder
  • Posts: 1244
(No subject)
« Reply #1 on: October 10, 2007, 09:58:10 PM »
Damn... that's from the hullside?  My glass was VERY thin on the sides of my FB... but then again your CCP is a heavier-duty rig.  I think the bottom of my hull might have been 1/2" thick.
Logged
October 10, 2007, 10:12:46 PM
Reply #2

John Jones

  • Information Offline
  • Posts: 2829
(No subject)
« Reply #2 on: October 10, 2007, 10:12:46 PM »
I'm with Rich.  My CCP sides are very thin.
Logged
Politics have no relation to morals.
Niccolo Machiavelli
Pages: 1   Go Up
« previous next »
 

SimplePortal 2.3.5 © 2008-2012, SimplePortal