Attention: Have only 1 page to see today

Author Topic: keep getting water in my fuel separators  (Read 288 times)

August 19, 2021, 03:13:19 AM
Read 288 times

cvtemp

  • Information Offline
  • Posts: 1
keep getting water in my fuel separators
« on: August 19, 2021, 03:13:19 AM »
Hi everyone - am new to the site - have a 2001 205 Osprey centre console that I imported in to Australia. Have been advised by my mechanic that yet again have a significant amount of water in the fuel separators requiring them to empty the tank. This is the 4th time this has happened over the last 4 years or so. Amount of water is way beyond the norm.
They have tried everything they say including pressure testing - additional O ring around the filler etc
Both them & me particularly are pulling our collective hair out.
Any suggestions would be very much appreciated?
Regards
Rick vB

August 19, 2021, 08:55:27 AM
Reply #1

Capt. Bob

  • ***
  • Information Offline
  • Global Moderator
  • Posts: 6446
Re: keep getting water in my fuel separators
« Reply #1 on: August 19, 2021, 08:55:27 AM »
Well, if you have emptied the tank and it has passed a pressure test then logic would dictate that the source of the water is the fuel supply.

Back in the 80's when we bought our fuel in the Fla. Keys, it was not uncommon to drain 8oz or more each time we ran. The old tanks at the marina were a constant source of water contaminated fuel.

Just a thought.
]
Capt. Bob
1991 210 Walkaround
2018 Yamaha 150 4 Stroke
"Reef or Madness IV"

August 19, 2021, 09:55:07 AM
Reply #2

RickK

  • *****
  • Information Offline
  • Administrator
  • Posts: 11282
Rick
1971 "170" with 115 Johnson (It's usable but not 100% finished)

1992 230 Explorer with 250 Yamaha

August 19, 2021, 11:25:00 AM
Reply #3

fitz73222

  • Information Offline
  • Mechanical Master
  • Posts: 1957
    • http://www.hudson-technologies.com/.
Re: keep getting water in my fuel separators
« Reply #3 on: August 19, 2021, 11:25:00 AM »
It is not entirely uncommon that during certain sea conditions that water can enter through the overboard vent if it has one. I had to install a stainless clamshell over my vent on my 22-2 to keep it from happening. Additionally, make sure you have the correct O-ring or gasket in your fuel fill cap so when it rains or during washdown that water is not entering there either. Water in fuel from petrol station is very rare these days, assuming the same standards are held in Australia.
1973 Aquasport 22-2, twin 115 Mercs
2000 Baycraft 175 flats boat, 60 Bigfoot Merc
1968 Boston Whaler 13, 25 Yamaha (project)
1966 Orlando Clipper 13, 9.9 Merc

August 19, 2021, 03:38:02 PM
Reply #4

plugger

  • Information Offline
  • Posts: 68
Re: keep getting water in my fuel separators
« Reply #4 on: August 19, 2021, 03:38:02 PM »
Agree it’s more likely at the source, the tank in the 205 is polly and not at all exposed to the elements


Somebody messing with your boat, I’m from Brooklyn i would put it lock on the cap to be sure

August 19, 2021, 09:19:35 PM
Reply #5

boatnamesue

  • Information Offline
  • Posts: 564
  • Jason
Re: keep getting water in my fuel separators
« Reply #5 on: August 19, 2021, 09:19:35 PM »
Well, if you have emptied the tank and it has passed a pressure test then logic would dictate that the source of the water is the fuel supply.

Agreed….gotta be the fuel source.  By chance have you been using the same fuel source past 4 years?
---------------
Jason
1976 AS 170
1998 S115TLRW

 


SimplePortal 2.3.5 © 2008-2012, SimplePortal