Welcome, Guest
Login
Register
Search
Home
Forum
Help
Site Rules
Advertise
Login
Register
Menu
Home
Forum
Help
Site Rules
Advertise
Login
Register
Classic AquaSport
/
Aquasport Model Rebuilds, Mods, Updates and Refreshes
/
Family Fisherman/Dual Console/Sport Rider Rebuilds
/
246 rebuild live from Delmarva!
You reached the limit of pages to see for today
« previous
next »
Print
Pages:
1
...
14
15
16
Go Down
Author
Topic: 246 rebuild live from Delmarva! (Read 12809 times)
July 31, 2014, 10:05:05 AM
Reply #225
Capt. Bob
Information
Global Moderator
Posts:
6445
Re: 246 rebuild live from Delmarva!
«
Reply #225 on:
July 31, 2014, 10:05:05 AM »
Quote from: "4shore"
I can't help but notice how floppy the sides of this boat are. Is this normal?
Well "floppy" is a relative term. The Aquas I've owned had flex along the hull sides. How much flex is bad, I don't know. A mid tier boat, it isn't going to be as stiff as a higher end hull. These craft are known for being rather light for their length allowing lower HP to propel them. Sounds like a typical Aqua hull to me but I'm not pushing on it either so.....
Not a real comparison but just a weak example, your hull is listed at 2550 lbs. (probably dry) while a 23 Contender is listed at 4200 lbs. dry weight.
I'm thinking you're fine.
Logged
]
Capt. Bob
1991 210 Walkaround
2018 Yamaha 150 4 Stroke
"Reef or Madness IV"
July 31, 2014, 10:21:14 AM
Reply #226
4shore
Information
Mid Atlantic
Posts:
121
Re: 246 rebuild live from Delmarva!
«
Reply #226 on:
July 31, 2014, 10:21:14 AM »
Fair enough. I have also been thinking about adding bulkheads between the stringers when removing the floor. As far as I can see there are no bulkheads fore or aft of the fuel tank coffins. Will this cause stress points or anything else? Seems to be common practice around here to add them in.
Logged
July 31, 2014, 01:08:53 PM
Reply #227
Capt. Bob
Information
Global Moderator
Posts:
6445
Re: 246 rebuild live from Delmarva!
«
Reply #227 on:
July 31, 2014, 01:08:53 PM »
Well, we haven't seen a lot of negative comments from those who do, assuming they're still around to post them :o .
Again, why not? Might make it a little quieter when you're hunting ducks.
Good luck.
Logged
]
Capt. Bob
1991 210 Walkaround
2018 Yamaha 150 4 Stroke
"Reef or Madness IV"
July 31, 2014, 02:05:38 PM
Reply #228
RickK
Information
Administrator
Posts:
11275
Re: 246 rebuild live from Delmarva!
«
Reply #228 on:
July 31, 2014, 02:05:38 PM »
While you're in there, why not. It would give the deck more support too.
Logged
Rick
1971 "170" with 115 Johnson (It's usable but not 100% finished)
1992 230 Explorer with 250 Yamaha
August 20, 2014, 07:37:01 PM
Reply #229
4shore
Information
Mid Atlantic
Posts:
121
Re: 246 rebuild live from Delmarva!
«
Reply #229 on:
August 20, 2014, 07:37:01 PM »
Fishbox done. Top,bottom and sides all insulated with 2" foam and glassed in
Spray foam is just there to help round out the corners. The low spot is where the pedestal seat goes and its backed with 3/4" ply
Logged
August 20, 2014, 07:47:16 PM
Reply #230
RickK
Information
Administrator
Posts:
11275
Re: 246 rebuild live from Delmarva!
«
Reply #230 on:
August 20, 2014, 07:47:16 PM »
How much you figure it/they weigh? Bet they look heavier than they are.
Logged
Rick
1971 "170" with 115 Johnson (It's usable but not 100% finished)
1992 230 Explorer with 250 Yamaha
August 20, 2014, 08:10:56 PM
Reply #231
4shore
Information
Mid Atlantic
Posts:
121
Re: 246 rebuild live from Delmarva!
«
Reply #231 on:
August 20, 2014, 08:10:56 PM »
30-50 is my guess. I can weigh it next time im working on it
Logged
March 17, 2016, 01:51:47 PM
Reply #232
TheKid
Information
Posts:
238
Re: 246 rebuild live from Delmarva!
«
Reply #232 on:
March 17, 2016, 01:51:47 PM »
This rebuild still happening? I wanted to make seat boxes for a long time. Also need to recore fuel hatch.
Would be nice to see finished job.
Logged
March 17, 2016, 05:27:32 PM
Reply #233
Capt. Bob
Information
Global Moderator
Posts:
6445
Re: 246 rebuild live from Delmarva!
«
Reply #233 on:
March 17, 2016, 05:27:32 PM »
4shore hasn't been active on the Forum in well over a year (17 months).
Logged
]
Capt. Bob
1991 210 Walkaround
2018 Yamaha 150 4 Stroke
"Reef or Madness IV"
June 01, 2020, 09:32:08 PM
Reply #234
4shore
Information
Mid Atlantic
Posts:
121
Re: 246 rebuild live from Delmarva!
«
Reply #234 on:
June 01, 2020, 09:32:08 PM »
Hey guys. Been a while....
I still have this boat and actually have a second of the same model that has a hard top and an older optimax.
Long story short I have switched teams and am at the tail end of a seacraft restoration. On top of that I’m building a house and moving soon. I want these boat to go to someone who will finish up the project.
I’m willing to let the whole package go CHEAP! Please text me at 443-735-7062 as I don’t check this site frequently.
Logged
June 16, 2020, 09:44:58 PM
Reply #235
4shore
Information
Mid Atlantic
Posts:
121
Re: 246 rebuild live from Delmarva!
«
Reply #235 on:
June 16, 2020, 09:44:58 PM »
Disregard.....sold.
Logged
Print
Pages:
1
...
14
15
16
Go Up
« previous
next »
Classic AquaSport
/
Aquasport Model Rebuilds, Mods, Updates and Refreshes
/
Family Fisherman/Dual Console/Sport Rider Rebuilds
/
246 rebuild live from Delmarva!
SimplePortal 2.3.5 © 2008-2012, SimplePortal