Aquasport Mechanicals - things that need a wrench, screwdriver or multimeter > Electrical

wiring connections

(1/1)

Cpt. Beyond:
hello,

 im getting close to wiring up my 82 170 and was wondering if anyone recommends using any anti corrosive agent on the connections to the instruments. i will be using terminations from west marine with heat shrink tubing built onto the connector. thanks again

RickK:
I would make all your connections clean and tight and when you're finished then I would apply a little bit of Di-electric grease on top of the connections to seal them up.

Capt. Bob:
You may also consider using a spray coating like Corrosion X or Fluid Film on the connections. I had very good and long lasting results with both when applied to my various gauge connections.

Good luck. :thumright:

Cpt. Beyond:
thanks for the advice fellas, will do

Navigation

[0] Message Index