Attention: Have only 1 page to see today

Author Topic: jack plate on 222  (Read 333 times)

June 20, 2020, 02:38:07 PM
Read 333 times

pmatt

  • Information Offline
  • Posts: 7
jack plate on 222
« on: June 20, 2020, 02:38:07 PM »
has anyone installed a hydraulic jack plate onto an Armstrong bracket? Bracket has a 200 hp Suzuki, 25" shaft.
Boat is 1974 222. Looking for performance input. I need to raise the motor up and thought it would be a good time to look into jackplate.
thanks

June 20, 2020, 11:46:54 PM
Reply #1

Ulysses485

  • Information Online
  • Posts: 299
Re: jack plate on 222
« Reply #1 on: June 20, 2020, 11:46:54 PM »
I was just thinking of this today for my future rebuild. Curious to hear as well.

1974' 240 CC - https://classicaquasport.com/smf/index.php?topic=15975.0
1970’ Flatback 222 - https://classicaquasport.com/smf/index.php?topic=15666.0
1981’ Osprey 22-2 - https://classicaquasport.com/smf/index.php?topic=15249.0
1971’ Flatback 222 - SOLD
1972' 240 Seahunter - SOLD

August 25, 2020, 05:05:53 PM
Reply #2

BkFL222

  • Information Offline
  • Posts: 6
Re: jack plate on 222
« Reply #2 on: August 25, 2020, 05:05:53 PM »
I'm trying to figure out the same thing. What would be the best length 20" or 25" motor? Would you go with a Porta Bracket or a swim platform?

August 25, 2020, 05:27:14 PM
Reply #3

mshugg

  • Information Offline
  • Master Rebuilder
  • Posts: 949
Re: jack plate on 222
« Reply #3 on: August 25, 2020, 05:27:14 PM »
The advantage of a jack plate is it lets you fine tune the height of the motor, but too low on the motor, coming off plane or backing down = really bad. I’d go with the 25” shaft for a net plus for shallow running without the negative potential  of submerging exhaust ports or powerhead.

 

SimplePortal 2.3.5 © 2008-2012, SimplePortal