Classic AquaSport
Aquasport Model Rebuilds, Mods, Updates and Refreshes => Center Console Professional (CCP) Rebuilds => Topic started by: ashefrin on July 24, 2017, 04:49:03 PM
-
I have a 19 osprey and in the gunnels there are holes for the fishing rods. the insert or sleeve has come out and is gone any idea how I can get replaements here is a picture of one
-
Ash, I have the same dilemma . I saw a while ago while browsing through some of the old rebuild threads there was a lengthy discussion on this very subject .perhaps Capt. Bob or RicKK can steer you in the right direction . I believe they are not available . I thought about bonding some PVC pipe together and then milling it down to size on my Harbor Freight wood lathe . Just Saying !
-
Can you show me a pic of where the sleeve is located?
Thanks.
-
Capt,
Thanks for answering here are a few pics 1 with no sleeve and 1 with they are on the sides I have a 19 Osprey any help would be appreciated....Andy
-
without Thanks again...Andy
-
You can cut some PVC pipe and glue it in place with some 5200 to replace the "sleeves"
-
Th marine has rod tubes in their catalog. Here's a link: http://thmarine.com/custom-rod-tubes
Basically just pvc with a flange.
-
You're looking for a rod grommet
(http://www.classicaquasport.com/gallery/data/500/rod_grommet.jpg) (http://www.classicaquasport.com/gallery/showphoto.php?photo=5921&title=rod-grommet&cat=500)
Here ya go.
http://classicaquasport.com/smf/index.php?topic=9671.msg83927#msg83927
Where to buy.
http://www.marineeast.com/a_sch/sch_det.asp?cid=06&pid=06_06
Good luck. :thumright:
-
This post helped me too! Thanks, have been looking for these for a while!
-
Welcome back home Capt Bob - glad a bear didn't have some fun with you on the adventure you were on. :thumleft:
Immediately he's helping the membership again as usual :bravo_2:
-
Good to be back.
Oh and it was moose and lobster that were threatening. Didn't see any live moose but ate a lot of lobster. :mrgreen:
-
These sleeves are exactly what I'm looking for, but I seem to not be able to find them for my 1987 250CCP.
The rod holes on my 250 are 3" and outer dimension should be 4". I would love to find these babies in White, preferably with no screw holes. I would 5200 them on. Any help would be appreciated !!
-
The rod trim rings I used (and linked to) measure 3 1/2" outside to outside. Doesn't leave a lot of bonding area on your case. Mine however fit snug inside the existing cutout.
I would call them and ask if one of these rings has the dims. you require. They were very helpful in selecting a size that fit my 91 WAC.
Good luck. :thumright:
-
Thank you Cap. Bob, I'll call them tomorrow .
-
I was able to find someone with a 3d printer and had the old one scanned and made new ones they came out pretty good picture attached