Menu
Attention: Have only 1 page to see today
« previous next »
Pages: 1   Go Down

Author Topic: motor getting stuck in up postion  (Read 666 times)

June 16, 2010, 04:59:17 PM
Read 666 times

aqua719

  • Information Offline
  • Posts: 35
motor getting stuck in up postion
« on: June 16, 2010, 04:59:17 PM »
the trim seems like it is sticking going up and getting stuck going down with out a little help ( leaning on it )
maybe low on fluid or needs to be replaced?

any advice?  :scratch:
Logged
June 16, 2010, 05:03:20 PM
Reply #1

John Jones

  • Information Offline
  • Posts: 2829
Re: motor getting stuck in up postion
« Reply #1 on: June 16, 2010, 05:03:20 PM »
I have seen that caused simply by corrosion/lack of grease on the tilt tube.
Logged
Politics have no relation to morals.
Niccolo Machiavelli
June 16, 2010, 05:07:32 PM
Reply #2

aqua719

  • Information Offline
  • Posts: 35
Re: motor getting stuck in up postion
« Reply #2 on: June 16, 2010, 05:07:32 PM »
Quote from: "John Jones"
I have seen that caused simply by corrosion/lack of grease on the tilt tube.
going to start by cleaning it down, checking the fluid, lubing it up etc. hopefully that will solve the problem
Logged
June 16, 2010, 06:02:28 PM
Reply #3

John Jones

  • Information Offline
  • Posts: 2829
Re: motor getting stuck in up postion
« Reply #3 on: June 16, 2010, 06:02:28 PM »
If it's low on fluid the pump will sound like it is pumping pea gravel.
Logged
Politics have no relation to morals.
Niccolo Machiavelli
Pages: 1   Go Up
« previous next »
 
SimplePortal 2.3.5 © 2008-2012, SimplePortal