Aquasport Model Rebuilds, Mods, Updates and Refreshes > 200 CCP Rebuilds
Fuel Tank coffin dimensions
GACTraveler:
Looking at replacing my fuel tank and found one at a good price that I think will fit. When the previous owner replaced the floor, he covered over everything and put in a 35 gallon tank with a front pick up. Its causing problems with the motor since the gas moves in the tank. Does anyone know the dimensions of the fuel tank area between the stringers on a 1984 200CCCP? Thanks
Capt. Bob:
I'm not sure this helps because it is the size of the tank itself that came with the hull from the factory. Of course we have no idea what was done to the actual coffin when the deck was replaced but assuming the coffin is still intact, this is what you would be working with.
https://classicaquasport.com/smf/index.php?topic=11420.msg112280#msg112280
General hull specs:
https://classicaquasport.com/smf/index.php?topic=14174.msg140663#msg140663
Note the 200 CCP and XF are the same hull with different caps.
No dims, just a pic.
https://classicaquasport.com/smf/index.php?topic=11872.msg119050#msg119050
Last one:
https://classicaquasport.com/smf/index.php?topic=11944.msg119975#msg119975
Trust this gives you a better idea what you're up against.
Good luck. :thumright:
jdupree:
I just pulled the tank in my '78 200 CCP. The tank coffin will measure very similar to the tank itself. The only difference will be the length. My tank was a 73 gallon. Here are the measurements of the tank.
72" Long
24" Wide (top)
20" Wide (bottom)
11" High or deep
As I said, the coffin will have very close measurements to the tank give or take a couple of inches. I can get the entire length of the coffin if you need it.
GACTraveler:
Thank you all very much. Great info.....now I gotta decide to break out the wallet
jdupree:
I just ordered mine last week from Phil with Alloy Metal Works out of Farmingdale, NY. This is the 3rd tank I have had him make. You might want to check him out.
Navigation
[0] Message Index
[#] Next page
Go to full version