Classic AquaSport
Aquasport Mechanicals - things that need a wrench, screwdriver or multimeter => Electrical => Topic started by: CTsalt12 on May 02, 2018, 09:28:04 AM
-
Hi All,
I need to replace my rigging sleeve going from my outboard to where the engine wires and cable meet the hull of my boat. I need to do this without taking all the wiring/cables out, because that would be a huge PITA. Meaning, I need a sleeve that I can fit around the cables.
I see I can get a zippered harness here, about 50 bucks shipped.
https://www.overtons.com/modperl/product/details.cgi?pdesc=T-H-Marine-Zippered-Rigging-Sleeve-48&i=316231&utm_medium=cpc&utm_source=googlebase&s_kwcid=googlepla&cvsfa=2587&cvsfe=2&cvsfhu=333136323331&s_kwcid=adwords__&gclid=EAIaIQobChMIx4D645zn2QIVEHZ-Ch0WognLEAQYAyABEgLi7vD_BwE
I'm wondering if anyone knows any nice cheap hacks here. Was almost thinking a wire loom, but they don't seem to make them above 2.5 inches, which I believe is a bit too narrow. Any ideas here?
-
This is what I used.
(http://www.classicaquasport.com/gallery/data/500/DSC06224.JPG) (http://www.classicaquasport.com/gallery/showphoto.php?photo=6917&title=dsc06224&cat=500)
-
Hmmm, did the tool I bought have that hole for a ratchet in it? If it did, I didn't notice and it's genius. (Now I have to go out and check)