The boat was created in 3 parts - the hull, the stringer/bottom liner piece and the liner/cap. The stringers were created out of the boat and then bonded into the hull. The liner was created out of the boat and then bonded to the stringers and sometimes, hull sides. On my 170, the cap was part of the liner. The liner sides were not bonded to the hull sides. The cap being screwed to the top of the hull sides was the attachment point for the liner sides and cap.

What is the length of the fuel tank sender on a 2000 175 Center Console?

more pics.  transom skin looks like swiss cheese

The outside joint of both stringers delaminated 1/4 to a 1/3 of the way towards the bow.  Do I have any worries of the hull twisting, etc.?  Also, I assume the order of rebuild is:
1. pull deck
2. pull cap
3. remove old transom from inside
4. redo stringers to keep hull form true
5. redo transom
6. attach stringers to transom

Thanks for everything All...... Duffy1470

Can you post a pic of them? Is it something that can be recored or are they plastic?

If you want to post a pic when you talk about your boat, which you should, follow the instructions here http://classicaquasport.com/smf/index.php?topic=12725.0  - don't attach them - you are limited by file size and guessing what size to make the file will usually reduce the pic too much. Uploading them into your "member gallery" is better for viewing and the system takes whatever size you upload and resizes it to the best size.
Spend a few minutes to absorb the instructions. It's really easy. Remember if using a phone to take pics, to hold the phone horizontal with the lens to the left.