Attention: Have 2 pages to see today

Author Topic: Rubber toggle switch covers  (Read 416 times)

April 06, 2018, 11:17:53 AM
Read 416 times

Powers

  • Information Offline
  • Posts: 2
Rubber toggle switch covers
« on: April 06, 2018, 11:17:53 AM »
Hi all,

I have an '87 170. One of my toggle switch rubber boots ripped and I figured it would be simple to find replacements and just replace all of them. NOPE. Ordered two sets by mail order and the thread on both are far too coarse. Went to the local hardware store with the one I have off to try to identify the thread- nothing SAE or metric matches up.  They appear to me to be original as the boat was very well kept. Any ideas? Trying not to have to remove the panel. This should been easy... :roll:

April 06, 2018, 01:49:53 PM
Reply #1

Capt. Bob

  • ***
  • Information Offline
  • Global Moderator
  • Posts: 6429
Re: Rubber toggle switch covers
« Reply #1 on: April 06, 2018, 01:49:53 PM »
I replaced my toggle boots on my 91 with this type/make.

https://www.iboats.com/shop/electrical/marine-switches-battery-ignition-rocker-and-toggle-switches/marine-toggle-switches/cole-hersee-weatherproof-toggle-boot-seal-gray.html

They fit the factory switches I have which I believe are Carling(sp). I do know that I replaced one of the toggle switches with a Sierra Marine and it fit that too.

This is the type I have.

https://www.westmarine.com/buy/sierra--tip-lit-toggle-switches--P010530848?recordNum=1

Good luck. :thumright:
]
Capt. Bob
1991 210 Walkaround
2018 Yamaha 150 4 Stroke
"Reef or Madness IV"

April 06, 2018, 04:14:37 PM
Reply #2

Powers

  • Information Offline
  • Posts: 2
Re: Rubber toggle switch covers
« Reply #2 on: April 06, 2018, 04:14:37 PM »
Thanks Cap!

Looks to be the one right next to the one you tagged. (full boot).

Thanks again.

 

SimplePortal 2.3.5 © 2008-2012, SimplePortal