Menu
Attention: Have only 1 page to see today
« previous next »
Pages: 1   Go Down

Author Topic: Shaft Length  (Read 486 times)

February 04, 2016, 01:21:28 PM
Read 486 times

Pepperkw

  • Information Offline
  • Posts: 4
Shaft Length
« on: February 04, 2016, 01:21:28 PM »
 :?: I have a 1986 22.2 Center Console. There is a 25in merc on it now. That Shaft seems VERY long!!!
Anyone know what the proper length is supposed to be on there? Would a 20in be better?
Logged
February 04, 2016, 02:10:18 PM
Reply #1

RickK

  • *****
  • Information Offline
  • Administrator
  • Posts: 11074
Re: Shaft Length
« Reply #1 on: February 04, 2016, 02:10:18 PM »
Measure from the notch in the transom (assuming it is the standard transom) to the bottom of the hull and that will tell you.
Logged
Rick
1971 "170" with 115 Johnson (It's usable but not 100% finished)

1992 230 Explorer with 250 Yamaha
February 04, 2016, 02:37:06 PM
Reply #2

Capt. Bob

  • ***
  • Information Offline
  • Global Moderator
  • Posts: 6435
Re: Shaft Length
« Reply #2 on: February 04, 2016, 02:37:06 PM »
Assuming you have an Osprey, transom height is 25"



Then again, you may have a CCP but that too has a 25" transom height.



Good luck. :thumright:
Logged
]
Capt. Bob
1991 210 Walkaround
2018 Yamaha 150 4 Stroke
"Reef or Madness IV"
February 05, 2016, 08:15:20 AM
Reply #3

CLM65

  • Information Offline
  • Posts: 1394
Re: Shaft Length
« Reply #3 on: February 05, 2016, 08:15:20 AM »
Where does the cavitation plate sit relative to the keel?
Logged
Craig

2002 205 Osprey, 200 HP Yamaha OX66


1967 22-2 Flatback (Rebuild in progress)
March 07, 2016, 12:10:27 PM
Reply #4

Pepperkw

  • Information Offline
  • Posts: 4
Re: Shaft Length
« Reply #4 on: March 07, 2016, 12:10:27 PM »
Sorry it took so long to get back... It was a 25in on second hole.
I have decided to sell the 22 because I bought an Osprey the other day :danceSm:
Logged
Pages: 1   Go Up
« previous next »
 
SimplePortal 2.3.5 © 2008-2012, SimplePortal