You reached the limit of pages to see for today

Author Topic: 1967 222 actual dimenions of inboard motor location fore/aft  (Read 204 times)

March 24, 2018, 10:13:55 AM
Read 204 times

barkdog

  • Information Offline
  • Posts: 4
1967 222 actual dimenions of inboard motor location fore/aft
« on: March 24, 2018, 10:13:55 AM »
hello, I have a 1967 222c flat back which I am rebuilding.  I will installing a inboard diesel.  the boat was an outboard so I do not know engine placement location.  if someone has the fore/aft measurements or has a inboard to measure from could you get me these.
please note dimension needed  ===   inches from inside of transom to back of engine block to bell housing joint==
if someone has or could take this measurement I would really appreciate it thanks craig

March 24, 2018, 07:55:53 PM
Reply #1

RickK

  • *****
  • Information Offline
  • Administrator
  • Posts: 11065
Re: 1967 222 actual dimenions of inboard motor location fore/aft
« Reply #1 on: March 24, 2018, 07:55:53 PM »
Whoa and WOW.  The FB was not offered in anything but an outboard. The depth of the stringers were shallow.
In the 70s they offered an inboard but the hull was a 12 degree model.
Rick
1971 "170" with 115 Johnson (It's usable but not 100% finished)

1992 230 Explorer with 250 Yamaha

 

SimplePortal 2.3.5 © 2008-2012, SimplePortal