Attention: Have 2 pages to see today

Author Topic: Rigging Sleeve Hack?  (Read 419 times)

May 02, 2018, 09:28:04 AM
Read 419 times

CTsalt12

  • Information Offline
  • Posts: 413
Rigging Sleeve Hack?
« on: May 02, 2018, 09:28:04 AM »
Hi All,

I need to replace my rigging sleeve going from my outboard to where the engine wires and cable meet the hull of my boat.  I need to do this without taking all the wiring/cables out, because that would be a huge PITA.  Meaning, I need a sleeve that I can fit around the cables.

I see I can get a zippered harness here, about 50 bucks shipped.

https://www.overtons.com/modperl/product/details.cgi?pdesc=T-H-Marine-Zippered-Rigging-Sleeve-48&i=316231&utm_medium=cpc&utm_source=googlebase&s_kwcid=googlepla&cvsfa=2587&cvsfe=2&cvsfhu=333136323331&s_kwcid=adwords__&gclid=EAIaIQobChMIx4D645zn2QIVEHZ-Ch0WognLEAQYAyABEgLi7vD_BwE

I'm wondering if anyone knows any nice cheap hacks here.  Was almost thinking a wire loom, but they don't seem to make them above 2.5 inches, which I believe is a bit too narrow.  Any ideas here?
Jimbo
1989 175 Osprey

May 02, 2018, 12:11:43 PM
Reply #1

Capt. Bob

  • ***
  • Information Offline
  • Global Moderator
  • Posts: 6429
Re: Rigging Sleeve Hack?
« Reply #1 on: May 02, 2018, 12:11:43 PM »
This is what I used.

]
Capt. Bob
1991 210 Walkaround
2018 Yamaha 150 4 Stroke
"Reef or Madness IV"

May 02, 2018, 07:48:15 PM
Reply #2

RickK

  • *****
  • Information Offline
  • Administrator
  • Posts: 11066
Re: Rigging Sleeve Hack?
« Reply #2 on: May 02, 2018, 07:48:15 PM »
Hmmm, did the tool I bought have that hole for a ratchet in it? If it did, I didn't notice and it's genius. (Now I have to go out and check)
Rick
1971 "170" with 115 Johnson (It's usable but not 100% finished)

1992 230 Explorer with 250 Yamaha

 

SimplePortal 2.3.5 © 2008-2012, SimplePortal