Author Topic: 150 ocean runner using to much oil (Read 447 times)

Thunderhead · « **on:** August 07, 2017, 06:47:57 PM »

I have a 98 200 osprey with a 150 ocean runner. The motor runs great, but uses 2 gallons of oil in about 6 hrs of running and smokes like a train. I had air in the fuel system due to a bad pick up tube, but that did not fix the problem. Any ideas?

1973aquasport · « **Reply #1 on:** August 07, 2017, 06:58:45 PM »

1. Remove cowling
2. Start engine
3. Find massive leak (it will be the one spewing 2 gallons of oil)

Thunderhead · « **Reply #2 on:** August 07, 2017, 07:19:01 PM »

There is no external leak. That would be to easy.

1973aquasport · « **Reply #3 on:** August 07, 2017, 07:34:55 PM »

If I'm not mistaken, don't these Johnsons have a VRO (Variable Ratio Oiling) pump? The idea behind the VRO is that it vary oiling to 100 to 1 at idle and 50 to 1 at full speed. It sounds like yours might be malfunctioning and is pumping far too much. I'd try to see about a replacement pump.

Thunderhead · « **Reply #4 on:** August 07, 2017, 07:40:11 PM »

The vro pump was replaced and has less than 20 hrs on it. I would hate to think the pump is bad already. I haven't had the chance to vacuum test the pump due to rain.

Thunderhead · « **Reply #5 on:** August 12, 2017, 07:24:37 AM »

After doing all of the test procedures in the manual, it turns out to be a bad diaphragm on the fuel side of the vro pump. Replaced pump and good to go.

Author Topic: 150 ocean runner using to much oil (Read 447 times)

Thunderhead

150 ocean runner using to much oil

1973aquasport

Re: 150 ocean runner using to much oil

Thunderhead

Re: 150 ocean runner using to much oil

1973aquasport

Re: 150 ocean runner using to much oil

Thunderhead

Re: 150 ocean runner using to much oil

Thunderhead

Re: 150 ocean runner using to much oil